tpm2net udp packet size
I setup a UDP tpm2net bridge with 6 16x16 channels and created a project with 6 16x16 patches.
My receiver is an ESP32 running on Arduino core: so no reassembly of packets supported.
Audectra is however producing one large packet with 4636 bytes of payload instead of the expected 4 packets with 775 bytes each.
This obviously fragments and is therefore unusable in my setup.
Additionally If I look at the reassembled payload itself, the data is only split up into 4 'chunks' instead of 6:
Other software (tried Jinx) behaves as expected when specifying 6 channels, by sending out 6 individual packets:
Is there a specific way the bridge or the patches have to be setup so audectra spits out individual packets?